Page 229 of 278

Re: What did you do to your rig today?

Posted: Fri Apr 26, 2019 7:35 pm
by Coolabah1au
Wow yes ok thanks [emoji120]


Sent from my iPhone using Tapatalk

Re: What did you do to your rig today?

Posted: Sat Apr 27, 2019 7:26 am
by Keith Morris
"tanks" here---
I finally got the "TANK" into action and went for a drive to the servo to pump up the tyres and then go for a run up and down the hiway to give the old thing a run. I enjoyed the drive and almost thought that I should keep going and end up in Wyalkatchem for a change of scenery, but then a rethink, and as my lady friend is driving over here from Perth to share my birthday I parked then "TANK" till next tyre check.
Helen and Paul have been gone for 5 days now and I miss their company, my kitchen is such a lonely place now.
Such a busy day and all after Anzac Day parade and service.
Keith

Re: What did you do to your rig today?

Posted: Sat Apr 27, 2019 2:35 pm
by supersparky
Here you go Dot.

20190426_123013.jpg
The silver strip at the bottom of the door is what I was referring to.

Re: What did you do to your rig today?

Posted: Sat May 18, 2019 1:14 pm
by bob r
Screwed a satking orbit automatic satellite dish to the roof works good.....so far

Bob

Re: What did you do to your rig today?

Posted: Sat May 18, 2019 2:32 pm
by Mrcoolabah1au
Wow yes ok thanks 🙏

Re: What did you do to your rig today?

Posted: Sat May 18, 2019 8:38 pm
by bagmaker
new battery
600 ah lithium.jpg

Re: What did you do to your rig today?

Posted: Sat May 18, 2019 9:09 pm
by Coolabah1au
Wow that mite do for a rainy day [emoji848]


Sent from my iPhone using Tapatalk

Re: What did you do to your rig today?

Posted: Mon May 20, 2019 3:31 pm
by T1 Terry
bagmaker wrote: Sat May 18, 2019 8:38 pm new battery
600 ah lithium.jpg
May I suggest replacing the link between the 2 battery packs with a cable with a big loop in it. Had a start battery failure in the Hino that turned out to be a fractured link between two cell packs, took ages to find it, the symptoms were a failed cell, because the voltage was always there but nothing there when attempting to start the engine, not enough material left in the copper link to carry the current required.

T1 Terry

Re: What did you do to your rig today?

Posted: Mon May 20, 2019 6:20 pm
by bagmaker
good idea T1, I will make something up a bit more flexible.
Cheers

Re: What did you do to your rig today?

Posted: Mon May 20, 2019 7:45 pm
by Greynomad
Maybe you could try LOTS of Alkaline AAAs??? :shock: