https://www.ozervnews.com

I'm still searching for the vents with the closing set up in them, that way the hot air will only go where I want it. I want one outlet in the bedroom area, one in the shower to act as a clothes dryer area as well as drying out the shower area after use, one in the kitchen area and one or two up front for when we are sitting and reading or computing. Might be handy while driving as well because the engine coolant supplied heater has been disconnected. The pips for it run all the way from the engine in the rear up to the front and one had sprung a leak, so the whole lot was disconnected.

T1 Terry

G replaced a fused fuse

But did he know why it fused?

Terry,vehicles from the seventies used those type of vents in the dash,would something like those do the job?.....I have been searching feebay and other sites but can't find any of the closing type................................Peter

BruceS wrote: ↑Mon Jun 10, 2019 4:29 pm But did he know why it fused?

G here do not know why but the fuse did not so much blow as melted the fuse holder which seems to indicate a heating over some time have managed to replace the fuse sort of. Fingers crossed for a successful repair.

Went to a truck wash at Townsville, tug and 5'er washed really well $148. good job.
Now camped at Coconut Glen CP. $10 pn, no power, parked down the back on lawn, for CMCA members only.

PeterH

2foot6 wrote: ↑Mon Jun 10, 2019 5:06 pm Terry,vehicles from the seventies used those type of vents in the dash,would something like those do the job?.....I have been searching feebay and other sites but can't find any of the closing type................................Peter

I hadn't thought about those, I'll have a look around he wreckers etc, but going back that far might put them into collector status

T1 Terry wrote: ↑Mon Jun 10, 2019 5:56 pm

2foot6 wrote: ↑Mon Jun 10, 2019 5:06 pm Terry,vehicles from the seventies used those type of vents in the dash,would something like those do the job?.....I have been searching feebay and other sites but can't find any of the closing type................................Peter

I hadn't thought about those, I'll have a look around he wreckers etc, but going back that far might put them into collector status

I got them here, bought 3 of them, look good, but still haven't fitted them.
http://www.autofrost.com.au/store/index ... uct_id=180

Cheers,

https://www.ebay.com.au/itm/Air-Vent-Ve ... ctupt=true
Doen't look like you can directly fix the tubing to it though.