There was significant difference in the "hole" on ours, the front is a one piece moulding in fg backed by 1.6mm galvabond, hope there is no difference in yours if he cuts them both from that template, but then if that happens it is his blue, yes ?
Vanishing Point, almost ready to vanish
Suzuki GV more than ready to go NOW !
Don't know where you are Kappy but in Qld there is a ADR on windscreen glass I got roust on when mine was doing a road worthy the glass was ok just it wasn't etched into the screen the asi/numbers .
Bernie .
Its easy for people to respond if they know what state your in because each states rules are different unless its Aus wide ..
The last lot of windows I had made for the bus they used acid etching labels to mark the window glass with the correct specs so I guess these suppliers will do a similar thing.
A person may fail many times, they only become a failure when they blame someone else John Burrows
If we have data, let’s look at data. If all we have are opinions, let’s go with mine. – Jim Barksdale, former Netscape CEO
If I knew how to put my location in the profile I would, I attempted to upload an avitar and I had to edit it such a size that I now can't find it. 15k.
The glass supplier advise the etching of the standard is in the corner of every sheet, sometimes it gets lost when cutting, they will do there best to ensure its retained when cutting.
Cheers
Kappy
Growing older is inevitable, growing up is optional.
Mine have no marks, they went in the cutting as they were in the corners and all our corners are round DOH!
No one has ever questioned my screens, been over the pits 3 times now, original certifier never looked, I think it is something they tend to forget about.
My advice was simply to spare you the pain, but in our case there has been none, so maybe don't worry about it too much.
From his comment, this is not unusual !
Vanishing Point, almost ready to vanish
Suzuki GV more than ready to go NOW !