Morning folks sitting on about 10c with expected maximum of 16c. And showers as well.
Tooth extraction went well as I did not feel it being removed. One stich to close the gap and a small filling done.
Take care and stay warm. Cheers Robert
Good morning daily
-
- Posts: 2264
- Joined: Fri Jul 28, 2017 9:03 am
- Location: Adelaide, SA
- Been thanked: 6 times
Re: Good morning daily
Good morning.
Bit fresh here as well Robert... showing 15.8 inside now but only because the fire is on
.
Yesterday was a good/bad day... good because the surgeon said everything was ok with Carol's knee.. All of about ten minutes and we could go... over 200 ks just for that
he could have rang us that info... that was also the bad bit...
But..I took the two batteries from the motorhome plus the lawnmower...and they gave me new one's..pissed off that they don't give full warrantys with the new ones
As we were going to Bundy I went and bought a new box of welding rods...plus I took a nut from under the motorhome with me on the odd chance they would have one.... they did..
plus new spring washers...
And we done shopping at Aldi's...so that's one shop I won't have to go to tomorrow when in Maryborough
Busy day...
Keep safe.
Bernie.
Bit fresh here as well Robert... showing 15.8 inside now but only because the fire is on
Yesterday was a good/bad day... good because the surgeon said everything was ok with Carol's knee.. All of about ten minutes and we could go... over 200 ks just for that
But..I took the two batteries from the motorhome plus the lawnmower...and they gave me new one's..pissed off that they don't give full warrantys with the new ones
As we were going to Bundy I went and bought a new box of welding rods...plus I took a nut from under the motorhome with me on the odd chance they would have one.... they did..
And we done shopping at Aldi's...so that's one shop I won't have to go to tomorrow when in Maryborough
Busy day...
Keep safe.
Bernie.
-
- Posts: 8788
- Joined: Mon Nov 26, 2012 7:00 pm
- Location: Home on the beautiful Gold Coast for a while.
- Has thanked: 83 times
- Been thanked: 66 times
Re: Good morning daily
Good morning everyone, from the not so sunny Strathbogie Ranges. It's cold, damp and drizzling rain. Might be a good day to sit around the Coonara heater and drink tea.
Safe travels all those out and about.
Safe travels all those out and about.
Cheers
David
David and Terrie
2006 Winnebago Alpine
Not all who wander are lost.
David
David and Terrie
2006 Winnebago Alpine
Not all who wander are lost.
-
- Posts: 3285
- Joined: Wed Dec 05, 2012 3:21 pm
- Location: Kotara, Newcastle
- Has thanked: 2 times
- Been thanked: 8 times
Re: Good morning daily
Good morning All. 14* with clear blue sky, forecast max of 19*.
I may crawl under the bus and enjoy myself Bernie, much as you did
. But, while I'm there, I'll check the diff oil level and top it up if necessary. I have already hung out some washing and put some more in the machine.
I haven't been up to much lately due to serious lower back pain when getting out of bed but, hopefully, we will take the bus for a trip sometime in the next few weeks.
George
I may crawl under the bus and enjoy myself Bernie, much as you did

I haven't been up to much lately due to serious lower back pain when getting out of bed but, hopefully, we will take the bus for a trip sometime in the next few weeks.
George
George, Julie, Leonie & Sean - Kotara, Newcastle
DIY 11.5M 1979 Bedford, Nissan/UD FE6T motor
DIY 11.5M 1979 Bedford, Nissan/UD FE6T motor
-
- Posts: 558
- Joined: Thu Nov 03, 2016 4:29 pm
- Location: Loxton
Re: Good morning daily
Fantastic day in the Riverland. Calm and sunny. Will give the tractor a birthday today with an oil change and coolant change. It dosn't get used much these days but as it has a forklift it is very handy to keep. Cheers John
Re: Good morning daily
Good morning.
I had a successful day...the sway bar bracket is all on finally...the secret was to remove all the nut's... made it easy peasy...sorta...
Plus I put the new start batteries in and fired it up...I did notice I had a better reading on the dashboard thingy..more than ever before... maybe the first batteries weren't up to scratch...
Plus I have the sheet of steel for the welding bench..
Picture included...
And today I'm off to the big smoke for our monthly shopping...
Keep safe.
Bernie.
I had a successful day...the sway bar bracket is all on finally...the secret was to remove all the nut's... made it easy peasy...sorta...
Plus I put the new start batteries in and fired it up...I did notice I had a better reading on the dashboard thingy..more than ever before... maybe the first batteries weren't up to scratch...
Plus I have the sheet of steel for the welding bench..
Picture included...
And today I'm off to the big smoke for our monthly shopping...
Keep safe.
Bernie.
You do not have the required permissions to view the files attached to this post.
-
- Posts: 8788
- Joined: Mon Nov 26, 2012 7:00 pm
- Location: Home on the beautiful Gold Coast for a while.
- Has thanked: 83 times
- Been thanked: 66 times
Re: Good morning daily
Good morning everyone. It was a white frost morning here, but beautiful sunny day ahead. Not a cloud in the sky at the mo'.
I'll be off to Pipers Creek soon. The I get play with the nearly 4yo gson for a day or so.i know who will get tired first.
Safe travels everybody, have a top day.
Edit. Spelling.
I'll be off to Pipers Creek soon. The I get play with the nearly 4yo gson for a day or so.i know who will get tired first.
Safe travels everybody, have a top day.
Edit. Spelling.
Last edited by supersparky on Thu Aug 07, 2025 6:47 pm, edited 1 time in total.
Cheers
David
David and Terrie
2006 Winnebago Alpine
Not all who wander are lost.
David
David and Terrie
2006 Winnebago Alpine
Not all who wander are lost.
-
- Posts: 24722
- Joined: Fri Nov 23, 2012 6:12 pm
- Location: Strathalbyn SA
- Been thanked: 37 times
Re: Good morning daily
You do not have the required permissions to view the files attached to this post.
Queen of the Banal & OT chatter and proud of it. If it offends you then tough titty titty bang bang.
-
- Posts: 4683
- Joined: Thu Apr 11, 2013 6:37 pm
- Location: bedford
- Has thanked: 43 times
- Been thanked: 37 times
Re: Good morning daily
Looking good Bernie.
You'll be able flip it over and finish the welds now that it's tacked together.
You'll be able flip it over and finish the welds now that it's tacked together.