What did you do to your rig today?

Newcastle George · Post by **Newcastle George** » Mon May 16, 2016 8:28 am

I found that my Sterling Battery to Battery charger is not working, it starts up, runs for 2 minuites, ligt comesopn saying that the starter battery is low (which is incorrect), then after another 2 minutes it shuts down.

George

Post by **BruceS** » Mon May 16, 2016 9:25 am

George is that when you are driving or sitting at idle?
Obviously you checked all connections and correct sized wires.

Post by **T1 Terry** » Mon May 16, 2016 9:29 am

Newcastle George wrote:I found that my Sterling Battery to Battery charger is not working, it starts up, runs for 2 minuites, ligt comesopn saying that the starter battery is low (which is incorrect), then after another 2 minutes it shuts down.

George

Couldn't possibly happen, just ask Ian (Powerstream), you must be doing something wrong

Newcastle George · Post by **Newcastle George** » Mon May 16, 2016 12:37 pm

Everything checked Bruce, fast idle 29V 30A from alternator, start battery at 27V prior to starting B-B. Spoke to Ian and will speak to him again this arvo with all info. He said he will contact Sterling on my behalf.

George

Jon and Kay · Post by **Jon and Kay** » Mon May 16, 2016 4:29 pm

Bought 1 x mc4 connector for $2.50 off eBay, when it arrived it was in a special cardboard envelope with $2 in stamps on it. Can't be much profit on that

Post by **T1 Terry** » Mon May 16, 2016 7:07 pm

Sent nearly all day chasing a low air pressure switch for the truck, finally found one I could adapt for the job where the truck block said he'd already check..... right next door to his yard

Then off for a weigh bridge ticket... in the mth it's sat there it's put on a Tonne, talk about getting fat and lazy. The last min dash to Service NSW and we now have rego plates, just no truck yet, hopefully in the morning, so now 4 days behind schedule and counting

It's not like it sat in his yard for the last mth or more

Helen Grose · Post by **Helen Grose** » Mon May 16, 2016 7:29 pm

Paul almost finished putting vinyl planks on our van floor will post photoes when we are finished
Take care Helen the boring one

Post by **BruceS** » Mon May 16, 2016 7:50 pm

No Helen, we need photos of HIM doing it!!!
Wait till he tries getting it right in that little corner & then snap it quick & run!!
You wanna do mine next Paul?

pop's coaster54 · Post by **pop's coaster54** » Mon May 16, 2016 9:15 pm

Well i've been a bit slack lately i have not done a thing for about 3 months to the coaster as Karen is battling cancer.

Dot · Post by **Dot** » Mon May 16, 2016 9:29 pm

pop's coaster54 wrote:Well i've been a bit slack lately i have not done a thing for about 3 months to the coaster as Karen is battling cancer.

Battles are there to be won so go for it Karen kick that C in it's rectum. All the best xxx

https://www.ozervnews.com

What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?