What did you do to your rig today?

Please feel free to describe your motorhome, campervan or caravan. (make, model, length etc)
Mrcoolabah1au
Posts: 2699
Joined: Wed Jan 23, 2013 3:36 pm
Location: Tocumwal on the Murray river

Re: What did you do to your rig today?

Post by Mrcoolabah1au »

What a wonderful trip you must have had 🚌🚌🚌
Coolabah1au
Wayne nini
User avatar
Neil
Posts: 22
Joined: Sat Jul 09, 2016 8:07 pm
Location: Pinjarra WA

Re: What did you do to your rig today?

Post by Neil »

Hey Terry, I've been trying to contact you since I got back to Oz on Saturday, any idea of your ETA in Pinjarra WA?

Sounds like you may still be on the East side, have you been to Esperance yet? :o

Cheers Neil
Everything will be ok in the end, if everything is not ok then it is not the end!
User avatar
BruceS
Site Admin
Posts: 9308
Joined: Thu Nov 22, 2012 7:32 pm
Location: Mannum, SA, 5238
Has thanked: 36 times
Been thanked: 36 times

Re: What did you do to your rig today?

Post by BruceS »

Not sure if Terry will be popping in here much in the next few days Neil.
He left Mannum for places over on the East Coast and then he intended coming back to Mannum before he heads over your way.
No doubt he'll be in touch once he reads this.
*******************
BruceS
Mannum, SA

********************
User avatar
Neil
Posts: 22
Joined: Sat Jul 09, 2016 8:07 pm
Location: Pinjarra WA

Re: What did you do to your rig today?

Post by Neil »

Thanks Bruce, I was wondering because when I last spoke to him he (they lol) intended to be in WA early June, other things must have popped up.

I'll watch & wait.

Thanks again

Neil.
Everything will be ok in the end, if everything is not ok then it is not the end!
User avatar
T1 Terry
Posts: 15999
Joined: Fri Nov 23, 2012 3:44 pm
Location: Mannum South Australia by the beautiful Murray River
Has thanked: 51 times
Been thanked: 32 times

Re: What did you do to your rig today?

Post by T1 Terry »

Well, today I removed the grill and upper grill section from the Mazda in an attempt to sort the heater issue. Fixed the cable so the tap turns on/off from inside rather than crawling on the ground under the front. Then I removed the intake part where it changes from inside air recirculated to fresh air.... first problem, the flap does not stay shut to keep the cold outside air out. Attempted to remove that part and the bolts sheared off.... didn't need that bit anyway, glued up the hole and put those bits on the bench. Next was to find out why the fan just blew cold air through the vent.... no idea so stuffed the holes with a pr of wool socks... bonus is the demister now works 8-) The heater does circulate warm air now so that bit sorted. A look at the front body panel revealed lots of very poorly applied fibreglass lifting off, made the silly mistake of pulling it and ended up with a rust hole near one side to the other :twisted: No matter how well the heater worked it wasn't going to be able to compete with this unregulated air flow. Out with the flyscreen wire and Selleys Armourflex, glued up the holes, put the grill bits back on to hide the evidence again and now we will see if it's a tad warmer on our trip to WA :D
No, we haven't left yet :lol:
A person may fail many times, they only become a failure when they blame someone else John Burrows
Those who struggle to become a leader, rarely know a clear direction forward for anyone but themselves
Mrcoolabah1au
Posts: 2699
Joined: Wed Jan 23, 2013 3:36 pm
Location: Tocumwal on the Murray river

Re: What did you do to your rig today?

Post by Mrcoolabah1au »

When want to come over to see ok 👌
Coolabah1au
Wayne nini
User avatar
Neil
Posts: 22
Joined: Sat Jul 09, 2016 8:07 pm
Location: Pinjarra WA

Re: What did you do to your rig today?

Post by Neil »

T1 Terry wrote: Sun Jul 30, 2017 5:42 pm Well, today I removed the grill and upper grill section from the Mazda in an attempt to sort the heater issue. Fixed the cable so the tap turns on/off from inside rather than crawling on the ground under the front. Then I removed the intake part where it changes from inside air recirculated to fresh air.... first problem, the flap does not stay shut to keep the cold outside air out. Attempted to remove that part and the bolts sheared off.... didn't need that bit anyway, glued up the hole and put those bits on the bench. Next was to find out why the fan just blew cold air through the vent.... no idea so stuffed the holes with a pr of wool socks... bonus is the demister now works 8-) The heater does circulate warm air now so that bit sorted. A look at the front body panel revealed lots of very poorly applied fibreglass lifting off, made the silly mistake of pulling it and ended up with a rust hole near one side to the other :twisted: No matter how well the heater worked it wasn't going to be able to compete with this unregulated air flow. Out with the flyscreen wire and Selleys Armourflex, glued up the holes, put the grill bits back on to hide the evidence again and now we will see if it's a tad warmer on our trip to WA :D
No, we haven't left yet :lol:
Sounds like you had a good day, one needs to keep oneself busy ha ha.

We are good for anytime you get here except the weekend of 18th to 22th August when we'll have the van away.

See ya's soon.

N & L
Everything will be ok in the end, if everything is not ok then it is not the end!
bagmaker
Posts: 886
Joined: Sun Jan 20, 2013 4:56 pm
Location: Victoria

Re: What did you do to your rig today?

Post by bagmaker »

finished some ceiling trim above the drivers seat, with reading lights
IMG_20170825_173949.jpg
You do not have the required permissions to view the files attached to this post.
Mrcoolabah1au
Posts: 2699
Joined: Wed Jan 23, 2013 3:36 pm
Location: Tocumwal on the Murray river

Re: What did you do to your rig today?

Post by Mrcoolabah1au »

Put the batteries charger on as usual got to every day now as to wet or overcast nearly everyday sun ☀️ only come out for an hour or two 😂😂😂
Coolabah1au
Wayne nini
User avatar
Greynomad
Posts: 9030
Joined: Tue Dec 04, 2012 4:16 pm
Location: Rutherglen, Vic.
Has thanked: 28 times
Been thanked: 63 times

Re: What did you do to your rig today?

Post by Greynomad »

Been packing Girt for a coupla weeks now... leaving for Cairns about 5~6 Sept. Date brought fwd from 9th 'coz house-sitters, who were coming from Coober Pedy, are now coming from Corowa (10km away)! So they can be here earlier. Had them around to share dinner & meet The Hounds they'll be feeding while we're away. Mutual Admiration Society... :roll:
Yesterday I walked 3.3km, according to my pedometer, :o and all I did was walk back & forth between house and Girt. Didn't even walk to the letterbox!
Decided it might be an idea to check contents of gas bottles (OK) and 240v power to fridge etc... (not OK!). Call to Licenced Electrician (a must for 240v side)... can't come until Monday. :( To Be Continued...
Now have to check that fridge works on gas.

Back soon. 8-)
Regards & God bless,
Ray
--
"Insufficient data for a meaningful answer."
Isaac Asimov, "The Last Question"

"I refuse to drink water, because of the disgusting things fish do in it"
W.C.Fields

Return to “About your outfit”