Red light

Mrcoolabah1au · Post by **Mrcoolabah1au** » Mon Sep 25, 2017 8:56 pm

Today for some reason the amp gauge was going crazy so I had a look at the junsi seem to be ok but the kemo time switch led was flashing

🛠

bagmaker · Post by **bagmaker** » Mon Sep 25, 2017 10:46 pm

loose earth??

Mrcoolabah1au · Post by **Mrcoolabah1au** » Tue Sep 26, 2017 7:45 am

Post by **T1 Terry** » Tue Sep 26, 2017 9:05 am

The read light means it is in a timer cycle, that means it must have received an alarm signal from the Junsi, so the battery is full? These things can happen when you turn the solar back on

Mrcoolabah1au · Post by **Mrcoolabah1au** » Tue Sep 26, 2017 12:47 pm

Ok yes soc 99.9

Mrcoolabah1au · Post by **Mrcoolabah1au** » Sun Oct 08, 2017 4:43 pm

So how do we control it with our have to check it every five minutes

I do usually look at it once a day but because the controls are inside the cupboard there no alarm

to make me look inside the at the control

Post by **BruceS** » Sun Oct 08, 2017 6:53 pm

Wayne don't you have the T1 controller set up? If so it controls it for you unless Nini turns it off again!!!

jon_d · Post by **jon_d** » Sun Oct 08, 2017 8:33 pm

Where was the switch that Nini turned off?

Mrcoolabah1au · Post by **Mrcoolabah1au** » Sun Oct 08, 2017 8:49 pm

On her side of the bed next to the wardrobe

Mrcoolabah1au · Post by **Mrcoolabah1au** » Sun Oct 08, 2017 11:02 pm

No Bruce as far a I know no black box victron , kemo timer, junsi, gavac, mega fuse 2 shunt , cut out switch , 240 to 12 change over switch and all the electrical rdc stuff plus all the shit next to the batteries downstairs

https://www.ozervnews.com

Red light

Red light

Re: Red light

Re: Red light

Re: Red light

Re: Red light

Re: Red light

Re: Red light

Re: Red light

Re: Red light

Re: Red light