Kemo timer

[Mrcoolabah1au]

How do you adjust the settings my red light only stay on one or two seconds not enough for it to do anything

[T1 Terry]

How do you adjust the settings my red light only stay on one or two seconds not enough for it to do anything

Under the unit on the left hand side there is an adjustment. It is very course so you need patience to get the time you are after, 1 min is ideal but I doubt you will be able to get exactly that, 50 secs and then 5 mins and getting it between the 2 is a very delicate operation. We changed to different timer boards that we extensively modify to suit our needs because of this problem and a few other problems but that timer works better with the PL series, the new method works best with the Dingo 20/20N...... but that is whole different headache on its own that I won't go into here.

T1 Terry

[Mrcoolabah1au]

Thanks mate will try and adjust it ok but if I have no success will leave it till next time we see you

[Mrcoolabah1au]

Try the settings this morning timed it on the stop watch red light come on for 90 second now go back to green for between 20 to 25 sec then back to red the soc at the moment is 99% just are well up 1/3.395 ,2/3.350 ,3.345 ,4,3/335 hope this is good

[T1 Terry]

Try the settings this morning timed it on the stop watch red light come on for 90 second now go back to green for between 20 to 25 sec then back to red the soc at the moment is 99% just are well up 1/3.395 ,2/3.350 ,3.345 ,4,3/335 hope this is good

The red light should not come on unless a cell reaches 3.6v or what ever the battery voltage is set to, so something doesn't sound right.

[Mrcoolabah1au]

I think you are Wright again the only way I can control to much solar coming is to use the kill switch which urn a lot of things off

[Mrcoolabah1au]

Can you tell me with Margret help what the new timer board set up is all about and how do I go about getting one

[jon_d]

Maybe an alternative to a kemotimer???

http://bed-electronics.com/

https://www.aliexpress.com/item/DC-12V- ... 08571.html

[Mrcoolabah1au]

Thanks Jon will look in to it ok